Before InduraFloor, solutions for damaged commercial flooring were defined by costly and laborious removal and replacement.
Our HydroBlok MVB is used to seal new and old concrete slab, especially problematic ones where previous failures have occurred, at over 1000 PSI Adhesion.
Used when continuous moisture is present and a concern for future performance exists.
Used when Hydrostatic Pressure is present or exceeding other products performance abilities.
No shot Blasting, scarifying, or sanding of sub substrate needed
Basements/Garages in Coastal Areas
Any Area Below Grade
Our system forms an impenetrable barrier that is resistant to chemicals, sewage, and water. Our formulation is designed to not only be extremely tough with hydrolytic stability and low permeability, but best of all we adhere to all USDA requirements for incidental food contact.
InduraFloor is USDA Approved - Acceptable for use in USDA Inspected Facilities
Last Updated: October 25 2021
Technical Data Sheet
Minimal surface preparation: sweep and pick up dry particulates and cleanse surface with mild detergent.
Incredible strength: Concrete will break before loss of adhesion occurs - >1000 PSI
Tack free/ready for topcoat in 3-6 hours
Simple roller application
25 minute pot life
Ready for light traffic in 3 hours
Flexible enough to move with any floor, but strong enough for heavy traffic
Designed specifically to work with all IKG floor coating
Any difficult to bond + rigid floor substrate that needs protection/ waterproofing - especially garages where moisture is present